Ditch Witch RT115 - Manual (Page 104)

RT115 Tier 3- PLOW ATTACHMENT
OPERATION
104 RT115 Tier 3 - PLOW ATTACHMENT
OPERATION
16. Move attachment speed/direction control to full speed
forward. PLOW WILL VIBRATE.
17. Reduce attachment speed to a point with the least tractor
vibration and the highest ground drive speed possible without
tire slippage.
18. Adjust vibrator speed if ROPS vibrates excessively.
19. When installation is complete, move plow swing to neutral.
20. With vibrator running, raise plow to ground level.
21. Move attachment speed/direction control to neutral.
22. Swivel seat to the drive position.
23. Engage parking brake and verify parking brake indicator is
on.
24. Lower backfill blade.
25. Turn ignition switch to STOP and remove product from plow.
26. Tilt steering wheel column down, start tractor and drive a
short distance away from work site.
27. Disengage axle lock by driving tractor in reverse 6’ (2 m).
28. Shut down tractor. See TRACTOR for proper shutdown
procedures.
NOTICE: Do not operate vibrator when plow is out of the
ground. This will cause excessive vibration resulting in
rapid wear, and possible damage to the unit and product
being installed.
16. Move attachment speed/direction control to full speed
forward. PLOW WILL VIBRATE.
17. Reduce attachment speed to a point with the least tractor
vibration and the highest ground drive speed possible without
tire slippage.
18. Adjust vibrator speed if ROPS vibrates excessively.
19. When installation is complete, move plow swing to neutral.
20. With vibrator running, raise plow to ground level.
21. Move attachment speed/direction control to neutral.
22. Swivel seat to the drive position.
23. Engage parking brake and verify parking brake indicator is
on.
24. Lower backfill blade.
25. Turn ignition switch to STOP and remove product from plow.
26. Tilt steering wheel column down, start tractor and drive a
short distance away from work site.
27. Disengage axle lock by driving tractor in reverse 6’ (2 m).
28. Shut down tractor. See TRACTOR for proper shutdown
procedures.
NOTICE: Do not operate vibrator when plow is out of the
ground. This will cause excessive vibration resulting in
rapid wear, and possible damage to the unit and product
being installed.