Ditch Witch RT115 - Manual (Page 119)

RT115 Tier 3 - SAW ATTACHMENT 119
SETUP
RT115 Tier 3 - SAW ATTACHMENT 119
SETUP
Before First Use and After Replacing Bits
Check bit clearance.
1. Check that all bits are properly secured.
2. Check that all bit retaining rings are secure.
3. Spin wheel by hand and listen for bits hitting diverters.
4. If bits hit diverters, repeat steps 1-3 to make sure bits are in
the proper location and secured at proper depth.
5. If bits do not hit diverters:
• Set parking brake.
• Fasten and adjust seat belt.
• Start tractor and adjust throttle.
• Raise saw slightly.
• Use attachment speed/direction control to rotate saw
slowly. As it rotates, listen for clicking sounds. If clicking
is present, repeat steps 1-4.
NOTICE:
• Unless otherwise instructed, all service should be
performed with tractor off.
• See weld notice at the end of this chapter.
Before First Use and After Replacing Bits
Check bit clearance.
1. Check that all bits are properly secured.
2. Check that all bit retaining rings are secure.
3. Spin wheel by hand and listen for bits hitting diverters.
4. If bits hit diverters, repeat steps 1-3 to make sure bits are in
the proper location and secured at proper depth.
5. If bits do not hit diverters:
• Set parking brake.
• Fasten and adjust seat belt.
• Start tractor and adjust throttle.
• Raise saw slightly.
• Use attachment speed/direction control to rotate saw
slowly. As it rotates, listen for clicking sounds. If clicking
is present, repeat steps 1-4.
NOTICE:
• Unless otherwise instructed, all service should be
performed with tractor off.
• See weld notice at the end of this chapter.