Ditch Witch FXT60 - Manual (Page 96)

FX60/FXT60 Tier 4 Operator’s Manual
Service - 95
10 Hour
CMW
®
Check Coolant Level
Check coolant level, with engine cool, at coolant
expansion tank every 10 hours. Maintain coolant
level at fill line. If low, add approved coolant.
To fill:
1. Slowly add coolant at expansion tank to fill line.
2. Start and operate engine for several minutes after it reaches normal operating temperature of 195°F
(90°C).
3. Stop engine and allow to cool.
4. Repeat steps until coolant level is correct.
Check Air Filter Indicator and Clean
Dust Trap
Check air filter indicator (1) and inspect dust trap
(2) for cracks every 10 hours. Change filter
elements when indicator reaches red zone.
NOTICE:
• The use of non-approved coolant may lead
to engine damage or premature engine
failure and will void engine warranty.
• See “Approved Coolant” on page 90 for list
of approved coolants.
NOTICE: Only open the air filter canister when
air restriction is indicated. Change the elements,
do not attempt to clean them.
• Compressed air or water may damage filter
elements.
• Tapping filter elements to loosen dirt may
damage filter seals.
1
2
j35om035h.eps j35om035h.eps