Denon AVR-2809CI - Manual (Page 56)

Get
ting Star
ted
Connections
Set
up
Remot
e Contr
ol
Multi-z
one
Inf
or
mation
Tr
oubleshooting
Specifi
cations
Presetting Radio Channels
(Preset Memory)
Your favorite broadcast channels can be preset so that you can
tune them in easily. Up to 56 channels can be preset.
To preset other channels, repeat steps 1 to 5.
NOTE
Preset channels are erased by overwriting them.
1 Press [A ~ G] to select the memory block (A to G).
2
Press [CHANNEL + –] or [NUMBER (1 ~ 8)] to select
the desired preset channel.
Listening to Preset Channels
1 Tune in the broadcast channel you want to preset.
2 Press [MEMO] .
3 Press [A ~ G] to select the block in which the channel
is to be preset.
4
Press [CHANNEL + –] or [NUMBER (1 ~ 8)] to select
the preset number.
5
Press [MEMO] again to complete the setting.
The strength of both the XM satellite and terrestrial signals can be
checked at menu “Input Setup” – “Antenna Aiming” (vpage 39).
Checking the XM Signal Strength and
Radio ID
1
Either turn or press [SAT TU2]
(AMP mode) to select “XM”.
2
Press until “SIGNAL” appears on the
display.
The display will switch as shown below, depending on the
reception conditions.
Display Status
GOOD Signal strength is good
MARGINAL Signal strength is marginal
WEAK Signal strength is weak
NO No signal
3 Adjust the position of the antenna until “SIGNAL:
GOOD” is shown on the display.
4
Press until the channel you want to check
(example: “XM001”) is displayed.
5
Press [ ] and select channel 0 (XM000).
The radio ID is shown on the display.
Radio ID
Operation on the Main Unit
uiop
Press , then turn
to select the preset channel.
Operation on the Main Remote control Unit.
Button located on both the main unit
and the remote control unit
BUTTON
Button only on the main unit Button only on the remote control unit [BUTTON]Symbols used to indicate buttons in this manual[NUMBER][MEMO][A ~ G][CHANNEL + –][ SAT TU][SEARCH]uiop[SAT TU1][ ][NUMBER][MEMO][A ~ G][CHANNEL + –][SAT TU2][ SAT TU][SEARCH][ENTER]uiop[ ]( mode)(AMP mode)XMSIRIUS( mode)(AMP mode)Pla
yback
Button only on the remote control unit [BUTTON]
Symbols used to indicate buttons in this manual
[NUMBER]
[MEMO]
[A ~ G]
[CHANNEL + –]
[ SAT TU]
[SEARCH]
uiop
[SAT TU1]
[ ]
[NUMBER]
[MEMO]
[A ~ G]
[CHANNEL + –]
[SAT TU2]
[ SAT TU]
[SEARCH]
[ENTER]
uiop
[ ]
( mode)
(AMP mode)
XM SIRIUS
( mode)
(AMP mode)
Pla
ybac
k