París needed for • frame assemblies, Step 2, Frame assemblies – Arrow Storage Products KM1010 User Manual
Page 15
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Step 2
• París Needed For •
Frame Assemblies
• 5986 Rear Wall Angle (2)
• 9917 Rear Wall Channel (2)
• 9923 Side Wall Channel (4)
• 9298 Side Wall Angle (4)
The main frame pieces reinforce the
walls. These pieces will later be in
stalled in the center and at the top
edge of the side walls and the rear
wall. Proceed as follows:
1
Overlap the
rear wall channel
pieces as shown in the figure and
fasten the two pieces together with
one bolt in the center hole (three
holes will align).
2
Make two
side wall channels
by
overlapping the side wall channel
pieces as shown. Fasten each set
together with
one bolt in the center
hole of each set.
3
Overlap the
rear wall angle
pieces as shown in the figure and
fasten them together with
one bolt in
the center hole.
4
Make two
side wall angles
by
overlapping the side wall angle piec
es as shown. Fasten each set togeth
er with
one bolt in the center hole.
5
Set the assemblies aside. You will
use them later.
Rear Wall Channel
118 1/8"
3,0m
9917
Side Wall Channels
111 5/8"
2,8m
9923
eC
Rear Wall Angle
118 1/8" 3,0m
Side Wall Angles
111 5/8"
2,8m
STEP
STEP
3
4