Parts needed for • floor frame assemblies, Step 1, Floor frame assemblies – Arrow Storage Products KM1010 User Manual
Page 14
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Step 1
• Parts Needed For •
Floor Frame Assemblies
>8934 Ramp (1)
> 9367 Front Floor Frame (2)
18936 Rear Floor Frame (2)
i
9299 Side Floor Frame (4)
The front floor frame is made up of
three pieces. The side floor frames
and the rear floor frame are made up
of two pieces. The holes in these
pieces will align when the pieces are
positioned with correct amount of
overlap. The illustrations belowshow
the properoverall length forthe sides,
rear and front. Proceed as follows:
1
Place the
front floor frames
as
shown. Center the
ramp,
with drain
holes facing outside, on top of the two
front floor frames. Join the frames by
inserting eight screws.
2
Overlap the
sidefloor frames
and
the
rear floor frames
as shown. The
holes in these pieces will align when
the pieces are positioned with cor
rect amount of overlap. See the illus
trations below for the proper overall
length of the side and rear floor frames.
Join the frames by inserting five bolts
into each frame set as shown.
3
Double check the length of each
and set these pieces aside for later
use.
Front Floor
Frame Assembly
119 3/8" 3,0m
DRAIN HOLES FACE*
OUTSIDE
f ©
Side Floor Frame 112 7/8"
■ '
2,9m
9299
RearFloor Frame 1193/8"
112 7/8" 2,9m
Side
112 7/8" 2,9m
119 3/8" 3,0m
Front & Rear
3/8" 3,0m
14