Positioning the speakers, Before connecting the ac cord, Important – Aiwa NSX-AV900 User Manual
Page 4: 1 connect the supplied antennas, 2 connect the front speakers, Front speakers, 3 connect the surround speakers, Setting up
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
SETTING UP
The Dolby Pro Logic system which is the biggest feature of this
stereo system provides you with audio visual entertainment in
your home.
Complete setting and connection of the main unit, supplied
speakers, your TV and video equipment according to the following
procedure.
POSITIONING THE SPEAKERS
To achieve the optimum effects obtainable with the Dolby Pro
Logic system, it is important to position the speakers properly.
Refer to the following illustration to find out the best location in
your room.
Before connecting the AC cord
The rated voltage of your unit shown on the rear panel is 120V
AC. Check that the rated voltage motches your local boltage.
IMPORTANT
Connect the speakers, antennas, and all optional equipment first.
Then connect the AC cord at the end.
CONNECTIONS
1 Connect the supplied antennas.
Connect the FM antenna to the FM 75 Q terminals and the
AM antenna to the AM LOOP terminal.
FM antenna
2 Connect the front speakers.
Connect the right speaker cord to SPEAKERS R terminals,
and the left to SPEAKERS L terminals.
® Front speakers
Position the front speakers so that the side ducts face away
from the main unit as shown in the illustration in page 1.
(D
Center speaker
Position in the center of the two front speakers. In addition,
position on or below the TV set, if connecting a TV set to the
unit.
@ Surround speakers
Place the surround speakers directly to the side of or slightly
behind the listening area. Align them horizontally, about 1
meter (3.2 feet) above ear height.
’ No sound is heard from the center and surround speakers when
the Dolby Pro Logic and DSP are set to off.
' The center speaker sounds only when the Dolby Pro Logic is
set to on.
The cords with white stripes should be connected to the O
terminals and the other cords to the
O
terminals.
3 Connect the surround speakers.
Connect the surround speaker cords to the SURROUND
SPEAKERS “1 terminals.
There is no difference between the surround speakers. Both
speakers can be connected as R (right) or L (left).
ENGLISH