Aiwa NSX-AV900 - Manual (Page 10)

TAPE PLAYBACK
PRESET NUMBER TUNING BASIC OPERATIONS
Use the remote control to select the preset number directly.
1 Press the TUNER/BANO button to select a band.
2 Press the numeric buttons to select a preset
number.
Example:
To select preset number 25, press the +10, +10 and 5 buttons.
To select preset number 10, press the +10 and 0 buttons.
Selecting a preset number on the main unit
Press the TUNER/BAND button to select a band. Then, press
the DIRECTION/PRESET button repeatedly.
Each time the button is pressed, the next highest number is
selected.
■ Deck 2
INSERTING TAPES
• On Deck 1, tapes are always played back on both sides.
On Deck 2, you can select a reverse mode to play back one or
both sides.
• Use Type I (normal), Type II (high/Cr02) or Type IV (metal)
tapes for playback.
Press theTAPE button and press the ± EJECT mark
to open the cassette holder.
About cassette tapes
• To prevent accidental erasure, break off the plastic tabs on the
cassette tape after recording with a screwdriver or other pointed tool.
To record on the tape again, cover the tab openings with adhesive
tape, etc. (On Type II tapes, take care not to cover the Type II tape
detection slot.)
' 120-minute or longer tapes are extremely thin and easily deformed
or damaged. They are not recommended.
' Take up any slack in the tape with a pencil or similar tool before use.
Slack tape may break or jam in the mechanism.
The Dolby Noise Reduction system reduces tape hiss noise.
For optimum performance when playing back a tape recorded with the
DOLBY NR system, turn on the DOLBY NR system.
Insert a tape with the exposed side down. Push the cassette
holder to close.
To select a reverse mode (Deck 2 only)
Each time the REV MODE button is pressed, the reverse mode
changes.
To play one side only, turn on Z..
To play from front side to back side once only, turn on T15.
To play both sides repeatedly, turn on CI5.
• When tapes are loaded in both decks, in the display
indicates Continuous Play.
9 ENGLISH