Aiwa NSX-AV900 - Manual (Page 22)

SETTING THE TIMER
1,2
The unit can be turned on at a specified time every day with the
built-in timer.
The duration for the timer-activated period can be set between
10 and 240 minutes in 10-minute steps.
• It this step is not completed within 4 seconds, repeat from
step 1.
5 Prepare the source.
To listen to a CD, load the disc to be piayed first on tray 1.
To listen to a tape, insert the tape into deck 1 or 2.
To listen to the radio, tune in to a station.
6 Press the POWER button to turn the unit off after
adjusting the voiume and tone.
© remains on the display after the power is turned off (timer
standby mode).
©at
:ifj
When the timer-on time is reached, the unit turns on and
begins play with the selected source.
Preparation
Make sure the clock is set correctly. (See page 6.)
Use the remote control.
1 Press the TiMER button on the remote controi
once to dispiay ©, and press the II SET button
within 4 seconds.
© is displayed, and the hour flashes.
©
■
If you do not press the 11 SET button within 4 seconds, another
operation may start.
2 Designate the hour of the timer-on time by
pressing the DOWN or UP button, and
the 11 SET button. Repeat to designate the minute
of the timer-on time.
After you designate the timer-on time, TIMER and one of the
source name flashes alternately on the display for 4 seconds.
3 Within 4 seconds, press one of the function
buttons to select a source.
“TIMER” and the selected source name flash alternately for 4
seconds. At this time, the selected function button does not
light up.
• If this step is not completed within 4 seconds, repeat from
step 1.
• If the TUNER button is pressed, the band cannot be selected
in this step.
4 Within 4 seconds, select the duration for the
timer-activated period with the DOWN or
UP button.
To check the specified time and source
Press the TIMER button on the remote control. The timer-on
time and the selected source name are displayed for 4 seconds.
However, the duration for the timer-activated period wiil not be
displayed.
TIMER RECORDING
Timer recording is applicable for TUNER and VIDEO/AUX (with
an external timer) sources only.
Press the TIMER button twice on the remote control so that
appears on the display, and press the II SET button within
4 seconds. Repeat the steps shown above from step 2 and
insert the tape to be recorded into deck 2 after step 5.
To cancel timer standby mode temporarily
Press the TIMER button on the remote control so that © or SI
disappears on the display.
To restore the timer standby mode, press again to display © or
Using the unit while the timer is set
You can use the unit normally after setting the timer.
Before turning off the power, repeat step 5 to prepare the source,
and adjust the volume and tone.
' Timer playback and timer recording will not begin unless the
power is turned off.
' Connected equipment cannot be turned on and off by the built-
in timer of this unit. Use an external timer.
*
m
21 ENGLISH