Troubleshooting guide, General there is no sound, Tuner section – Aiwa NSX-AV900 User Manual
Page 26: Cassette deck section the tape does not run, Cd player section the cd player does not play, To reset, Troubleshooting guide parts index
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
TROUBLESHOOTING GUIDE
PARTS INDEX
If the unit fails to perform as described in these Operating
instructions, check the foilowing guide.
GENERAL
There is no sound.
• Is the AC cord connected properly?
• is there a bad connection? (-► page 3)
• There may be a short circuit in the speaker terminais.
-* Disconnect the AC cord, then correct the speaker
connections.
• Was an incorrect function button pressed?
Sound is emitted from one speaker oniy.
• Is the other speaker disconnected?
The output sound is not stereo.
• Is the Karaoke function turned on? (-r page 19)
An erroneous display or a malfunction occurs.
-» Reset the unit as stated below.
TUNER SECTION
There is constant, wave-like static.
• Is the antenna connected properly? (-» page 3)
• Is the signal weak?
-» Connect an outdoor antenna.
The reception contains noise interferences or the sound
is distorted.
• Is the system picking up external noise or multipath distortion?
-» Change the orientation of the antenna.
-► Move the unit away from other electrical appliances.
CASSETTE DECK SECTION
The tape does not run.
• Is deck 2 in pause mode? (-* page 9)
The sound is off-balance or not adequately high.
• Is the playback head dirty? (-► page 23)
Recording is not possible.
• Is the erasure prevention tab on the tape broken off? (-+ page
9)
• Is the recording head dirty? (-+ page 23)
Erasure is not possible. .
• Is the erasure head dirty? (-► page 23)
• Is a metal tape being used?
High frequency sound is not emitted.
• Is a tape recorded without Doiby NR played back with the Doiby
NR system operating? (-► page 10)
• Is the recording/playback head dirty? (-» page 23)
CD PLAYER SECTION
The CD player does not play.
• is the disc correctiy inserted? (-► page 11)
• Is the disc dirty? (-> page 23)
• Is the lens affected by condensation?
■
-» Wait approximateiy one hour and try again.
Instructions about each part on the main unit or remote
are indicated on the pages iisted below.
(in alphabetic order)
Parts
Pages
BALANCE
6,17
BBE
6
CD
11
CD EDIT/CHECK (EDIT/CHECK)
11, 15, 16
■ CLEAR
8, 10, 11
CLOCK
6
DEMO
5
◄ ► DiRECTION/PRESET
9, 10, 11
DISC CHANGE
11
DISC DIRECT PLAY
11
DOLBY NR
10
DOLBY PRO LOGIC
17
DOWN
8, 10, 11
EDIT/CHECK (CD EDIT/CHECK)
11, 15, 16
GEO
7
KARAOKE (VOCAL FADER/MULTIPLEX)
19
KARAOKE ENTER
20
MANUAL SELECT (TEST)
17
MIC 1, MIC 2
18
MIC MIXING
18
± OPEN/CLOSE
11
PHONES
7
POWER
5
PRGM
12
RANDOM
12
• C/O) REC/REC MUTE
13
REPEAT/MONO TUNER
8, 12
REV MODE (DECK 2)
9
II
SET
8, 10, 11
SLEEP
22
SURROUND
7
SYNC DUB NORMAL/HIGH
14
TAPE/DECK 1/2
9, 13
T-BASS
6
TIMER
21
TUNER/BAND
8
►M, ►► UP
8, 10, 11
VIDEO/AUX
23
VOCAL FADER/MULTIPLEX (KARAOKE)
19
VOLUME
6
0-9,+10
12
To reset
If an unusual condition occurs in the display window or the
cassette decks, reset the unit as foilows.
1 Press the POWER button to turn off the power.
2
Press the POWER button to turn the power back on while
pressing the ■ CLEAR button. Everything stored in memory
after purchase is canceled.
If the power cannot be turned off in step 1 because of a malfunction,
reset by disconnecting the AC cord and repeat step 2.
25
ENGLISH