5 prepare the source, Sehing the sleep timer, 1 press the sleep button – Aiwa CX-NMT50 User Manual

Page 23: To check the specified time and source, To cancel timer standby mode temporarily, Using the unit while the timer is set, Timer recording, To cancel the sleep timer, Setting the sleep timer

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

The d uration for the timer-activated period can be set between

5 and 240 minutes in 5-minute steps.
• if this step is not compieted within 4 seconds, repeat from

step 1.

5 Prepare the source.

To listen to a CD, ioad the disc to be piayed first on tray 1.
To listen to a tape, insert the tape into deck 1 or 2.
To listen to the radio, tune in to a station.

6 Press the POWER button to turn the unit off after

adjusting the volume and tone.

i !

i i

i f-j.

:•••"

i i..i'

"1 1

When the timer-on time is reached, the unit turns on and
begins play with the seiected source.

• The volume level is automatically set to 16 when the power

is turned off with the volume level set to 17 or more.

SEHiNG THE SLEEP TIMER

ih“

□

Z
<

-I

The unit can be turned off automatically at a specified time.

Use the remote control.

1 Press the SLEEP button.

To check the specified time and source

Press the TIMER button. The timer-on time, the selected source
name and the duration for the timer-activated period are displayed
for 4 seconds.

nocK rasco

POP dVu : i

i..... n

n ! i

/ \

To cancel timer standby mode temporarily

Press the TIMER button repeatedly so that 0 or 0REC

disappears on the display.
To restore the timer standby mode, press again to display © or
©REC.

Using the unit while the timer is set

You can use the unit normally after setting the timer.

Before turning off the power, repeat step 5 to prepare the source,

and adjust the volume and tone.

' Timer playback and timer recording will not begin unless the

power is turned off.

' Connected equipment cannot be turned on and off by the built-

in timer of this unit. Use an external timer.

TIMER RECORDING

Timer recording is applicable for TUNER and VIDEO/AUX (with

an external timer) sources only.

within 4 seconds.

Carry out the steps of “SETTING THE TIMER” from step 2 and
insert the tape to be recorded into deck 2 after step 5.

2 Within 4 seconds, press the ◄◄ or button

to specify the time until the power is turned off.

Each time the button is pressed, the time changes between 5

and 240 minutes in 5-minute steps.

Specified time

RC/IK UISCO ;........ ;

’•0^ LY- „J

! ■■■■■•

n I

;

To check the time remaining until the power is turned off

Press the SLEEP button once. The remaining time is displayed

for 4 seconds.

To cancel the sleep timer

Press the SLEEP button twice so that “SLEEP” on the display
disappears.

ENGLISH 2 2