beautypg.com

Al edit recording, 1 insert the tape into deck 2, 2 press the cd button and load the disc(s) – Aiwa CX-NMT50 User Manual

Page 16: 3 press the cd edit/check button once, To stop recording, To check the order of the programmed track numbers, To add tracks from other discs to the edit program, Time on cassette tapes and editing time, Al edit recording ii

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

Al EDIT RECORDING

The Al edit function enabies CD recording without worrying about
tape iength and track iength. When a CD is inserted, the unit
automatically calculates the total track length. If necessary, the
order of tracks is rearranged so that no track is cut short.
(Al: Artificial Intelligence)

Al edit recording will not start from a point halfway into the tape.
The tape must be recorded from the beginning of either side.

1 Insert the tape into deck 2.

Insert the tape with the side to be recorded on first facing out

from the unit.

2 Press the CD button and load the disc(s).

3 Press the CD EDIT/CHECK button once.

“EDIT” and “Al” light up on the display.

Al

\ I /

!.... ■■■ U L

j

^

EDIT

I

When “PRGM” Is displayed, press the CD EDIT/CHECK
button again.

4 Press one of the DISC DIRECT PLAY buttons to

select a disc.

5 Press the ◄◄ or ►► button to designate the tape

length.

10 to 99 minutes can be specified.
In a few seconds, the microcomputer determines the tracks

to be recorded on each side of the tape.
• The numbered buttons on the remote control are also

available to designate the tape length.

Example: When using a 60-minute tape, press the 6 and 0

buttons.

Tape length

Tape side A

(front side)

Selected
tracks for side A

o

6 Press the # REC/REC MUTE button to start

recording.

The tape is rewound to the beginning of the front side, the

lead segment is played through for 10 seconds, and recording
starts. When recording on the front (side A) ends, recording
on the back (side B) starts.

To stop recording

Press the ■ button. Recording and CD play stop simultaneously.

To clear the edit program

Press the ■ CLEAR button twice so that “EDIT” disappears on

the display.

To check the order of the programmed track numbers

Before recording, press the CD EDIT/CHECK button to select
side A or B, and press the ◄◄ or ►► button repeatedly.

Programmed

track numbers

Track number

I

Program number

To add tracks from other discs to the edit program

If there is any time remaining on the tape after step 5, you can

add tracks from other discs in the CD compartment.
1 Press the CD EDIT/CHECK button to select side A or B.
2 Press one of the DISC DIRECT PLAY buttons to select a disc.
3 Press the numbered buttons on the remote control to select

tracks. PRGM appears on the display.
A track whose playing time is longer than the remaining time
cannot be programmed.

4 Repeat steps 2 and 3 to add more tracks.

Time on cassette tapes and editing time
The actual cassette recording time is usually a little longer than
the specified recording time printed on the label. This unit can
program tracks to use the extra time. When the total recording
time is a little longer than the tape’s specified recording time
after editing, the display shows the extra time (without a minus
mark), instead of the time remaining on the tape (with the minus
mark).

' Recording is inhibited if the erasure prevention tab on either

side of the tape is broken off.

' The Al edit function cannot be used with discs containing 31

tracks or more.

Remaining

time of side A

15

ENGLISH