Aiwa CX-NMT50 - Manual (Page 12)

TAPE PLAYBACK
BASIC OPERATIONS
• On deck 1, tapes are always played back on both sides.
On deck 2, you can select a reverse mode to play back one or
both sides.
• Use Type I (normal), Type II (high/CrOa) or Type IV (metal)
tapes for playback.
1 Press the TAPE button and press the ± EJECT
mark to open the cassette holder.
When tapes are loaded In both decks
Press the TAPE button first to select a deck.
The selected deck number is displayed.
To stop play, press the ■ button.
To pause play (deck 2 only), press the II button. To resume
play, press again.
To change the playback side, press the DIRECTION/
PRESET button in play or pause mode.
To fast forward or rewind, press the ◄◄ or ►► button. Then
press the ■ button to stop the tape.
To start play when the power is off (Direct Piay Function)
Press the TAPE button. The power is turned on and play of the
Inserted tape begins.
To set the tape counter to 0000
Press the ■ CLEAR button in stop mode.
The counter is also set to 0000 when the cassette holder is
opened.
If a television is used near this unit during tape playback, noise
may be heard from the speakers. In this case, turn the television
off.
insert a tape with the exposed side down. Push the cassette
holder to close.
2 Press the button to start play.
Playing deck number
The tape counter indicates
the tape running length.
-.............................................................................................
Playback side indicator
►: The front side is being played (forward).
I : The back side is being played (reverse).
To select a reverse mode (deck 2 only)
Each time the REV MODE button is pressed, the reverse mode
changes.
63
To play one side only, select Z..
To play from front side to reverse side once only, select Z').
To play both sides repeatedly, select C!I3.
• When tapes are loaded in both decks, T3 on the display
indicates Continuous Play.
1 1
ENGLISH