Aiwa CX-NA71 - Manual (Page 23)

The duration for the timer-activated period can be set between
5 and 240 minutes in 5-minute steps.
• If this step is not compieted within 4 seconds, repeat from
step 1.
5 Prepare the source.
To listen to a CD, ioad the disc to be piayed first on tray 1.
To listen to a tape, insert the tape into deck 1 or 2.
To listen to the radio, tune in to a station.
6 Press the POWER button to turn the unit off after
adjusting the volume and tone.
© remains on the dispiay after the power is turned off (timer
standby mode).
©
When the timer-on time is reached, the unit turns on and
begins piay with the seiected source.
• The voiume ievel is automaticaily set to 16 when the power
is turned off with the voiume ievei set to 17 or more.
To check the specified time and source
Press the TiiVIER button. The timer-on time, the seiected source
name and the duration for the timer-activated period are dispiayed
for 4 seconds.
To cancel timer standby mode temporarily
Press the TIMER button repeatedly so that © or ©REC
disappears on the display.
To restore the timer standby mode, press again to dispiay © or
©REC.
Using the unit while the timer is set
You can use the unit normally after setting the timer.
Before turning off the power, repeat step 5 to prepare the source,
and adjust the volume and tone. •
• Timer playback and timer recording will not begin unless the
power is turned off.
• Connected equipment cannot be turned on and off by the built-
in timer of this unit. Use an external timer.
SEHING THE SLEEP TIIVIER
o
o
_ _ o
oc
UJ
s
i=
a
z
<
o
The unit can be turned off automatically at a specified time.
Use the remote control.
1 Press the SLEEP button.
2 Within 4 seconds, press the ◄◄ or ►► button
to specify the time until the power is turned off.
Each time the button is pressed, the time changes between 5
and 240 minutes in 5-minute steps.
Specified time
To check the time remaining untii the power is turned off
Press the SLEEP button once. The remaining time is displayed
for 4 seconds.
To cancel the sleep timer
Press the SLEEP button twice so that “SLEEP” on the display
disappears.
TIMER RECORDING
Timer recording is applicable for TUNER and VIDEO/AUX (with
an external timer) sources only.
Press the TIMER button twice so that ©REC appears on the
display, and press the II SET button within 4 seconds.
Repeat the steps shown above from step 2 and insert the tape
to be recorded into deck 2 after step 5.
ENGLISH
22