Aiwa CX-NA71 - Manual (Page 16)

I
BASIC RECORDING
This section expiains how to record from the tuner, CD piayer, or
externai equipment.
Preparation
• Set the tape to the point where recording wiii start.
• Use Type I (normai) and Type II (high/Cr02) tapes for recording.
To stop recording, press the ■ button.
To pause recording, press the II button. (Appiicabie when the
source is TUNER, ViDEO/AUX or MD.) To resume recording,
press again.
INSERTING BLANK SPACES
insertion of 4-second blank spaces enables you to activate the
Music Sensor function. (Applicable when the source is TUNER,
VIDEO/AUX or MD)
1 Press the • REC/REC MUTE button during recording or
while in recording pause mode.
l:l=lH on the display flashes for 4 seconds and the tape runs
without recording. After 4 seconds, the deck enters the
recording pause mode.
2 Press the II button to resume recording.
To insert a blank Space of less than 4 seconds, press the #
REC/REC MUTE button again while i;ia^ is flashing.
To insert blank spaces of more than 4 seconds, after the
deck enters recording pause mode, press the # REC/REC
MUTE button again. Each time the button is pressed, a 4-second
blank space is added-
1 Insert the tape to be recorded on into deck 2.
Insert the tape with the side to be recorded on first facing
out from the unit.
2 Press the REV MODE button to select the reverse
mode.
To record on one side only, select H.
To record on both Sides, select or CÜ3.
3 Press the DOLBY NR button to turn Dolby NR on
or off. ^
To record with DOLBY NR, turn on □□ NR.
To record without DOLBY NR, turn off □□ NR.
4 Press one of the function buttons and prepare
the source to be recorded.
•To record from a CD, press the CD button and load the
disc(s). .
To record from a radio broadcast, press the TUNER button
and tune in to a station.
To record from the connected source, press the VIDEO/
AUX or MD buttpn and play.
5 Press the • REC/REC MUTE button to start
recording.
/i-.V
»e -f
¿P
When the selected function is CD, playback and recording
start simultaneously.
To erase a recording
Make sure the microphone is not connected to this unit.
1 Insert the tape to be erased into deck 2 and press the TAPE/
DECK 1/2 button to display “TP 2”.
2 Set the tape to the point where the erasure is to be started.
3 Set the reverse mode by pressing the REV MODE button.
4 Press the • REC/REC MUTE button to start the erasure.
15
ENGLISH