Setting the clock, Setting the timer, To display the current time – Aiwa CX-NA71 User Manual

Page 22: To switch to thé 24-hour standard, Preparation, Setting the clock setting the timer

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

SETTING THE CLOCK

SETTING THE TIMER

Press the CLOCK button on the remote control,

and press the II SET button within 4 seconds.

Press the ◄◄ DOWN or ►► UP button to

designate the hour, and press the II SET button.

The hour stops flashing and the minute starts flashing.

Press the ◄◄ DOWN or ►► UP button to

designate the minute, and press the II SET
button.

The minute stops flashing on the display and the clock starts
from 00 seconds.

To display the current time

Press the CLOCK button on the remote control. The time is

displayed for 4 seconds.

However, the time cannot be displayed during recording.

To switch to thé 24-hour standard .

Press the CLOCK button on the remote control and then press

the ■ button within 4 seconds.

Repeat the same procedure to restore the 12-hour standard.

If the clock display flashes

This is caused by a power Interruption: The current time needs
to be reset.

If power is interrupted for more than approximately 24 hours,

all settings stored in memory after purchase need to be reset.

3
1,2

The unit can be turned on at a specified time every day with the

built-in timer.

Preparation

Make sure the clock is set correctly.

Use the remote control.

Press the TIMER button once to display ©, and

press the II SET button within 4 seconds.

If you press the

SET button after 4 seconds, another

operation may start.

Designate the hour of the timer-on time by

pressing

the

DOWN

button,

and

press the 11 SET button. Repeat to designate the

minute of the timer-on time.

After you designate the timer^on time, one of the source name
flashes on the display for 4 seconds.

3 Within 4 seconds, press one of the function

buttons to select a source.

The selected source name flashes for 4 seconds. At this time,
the selected function button does not light up.
• If this step is not completed within 4 seconds, repeat from

step 1.

• If the TUNER button is pressed, the band cannot be selected

in this step.

Within 4 seconds, select the duration for the

timer-activated period with the M-^i DOWN or

UP button.

ENGLISH