Canon B820 - Manual (Page 60)

6-7
R
E
CE
IVIN
G
DO
CU
M
E
N
T
S
6
4 Use [ ] or [ ] to select the type of CALL REJECTION setting (FAX-B840 only) you want.
Press [Start/Copy].
You can select from the followings:
• ANONYMOUS: The fax rejects calls from any callers who have blocked their phone/fax number
from the Caller ID service.
• SELECTIVE: The fax rejects calls from specific phone/fax numbers you place in NUMBER TO
REJECT list (see below).
• OUT OF AREA: The fax rejects calls from any callers in an area that does not have the Caller ID
service.
• SHOW IN HISTORY?: Determine if the fax stores phone/fax number for rejected calls in memory.
5 Use [ ] or [ ] to select ON (YES).
Press [Start/Copy].
• If you set to OFF, the setting goes on to the next CALL REJECTION setting.
• If you set SHOW IN HISTORY? to YES or NO, the setting returns to ANONYMOUS.
6 • If you set ANONYMOUS or OUT OF AREA to ON, proceed to step 11.
• If you set SELECTIVE to ON, register the specific phone/fax numbers you want to reject in
NUMBER TO REJECT list. Follow the steps below.
7 Press [Start/Copy].
8 Use [ ] or [ ] to select the number of NUMBER TO REJECT list (00-09) under which you
want to register the phone/fax number.
Press [Start/Copy].
9 Enter the phone/fax number using the numeric buttons.
Press [Start/Copy].
10 To assign additional numbers, repeat the procedure from step 8.
To finish, press [Function].
Press [Start/Copy].
11 Use [ ] or [ ] to select PLAY MESSAGE or DISCONNECT.
Press [Start/Copy].
• PLAY MESSAGE: The call will be disconnected after the ALT OUTGOING MSG (see p. 7-1) is
played. If you set SELECTIVE to ON in step 5, and want to select this setting, OUTGOING
MESSAGE must have been recorded.
• DISCONNECT: The call will be disconnected without notice.
12 Press [Stop] to return to standby mode.