Canon B820 - Manual (Page 77)

7-15
USI
NG T
A
M
M
O
D
E
(
F
A
X
-B
84
0 only
)
7
When a forwarded call is received
When FWD SETTINGS is set to ON, telephone messages recorded when the fax is set to TAM
MODE will be automatically forwarded to a registered forwarding number.
1 A call is received at the forwarding number.
2 When you answer the phone you will hear your forwarding message.
3 Press [#] while the forwarding message is playing.
If you have not set a forwarding message, press [#] when you hear the tone.
4 Enter your password when you hear the beeps.
• When PIN ENTRY is set to OFF (see p. 7-14), step 4 is not required.
• If you enter an invalid password, you will hear an error tone. If you enter two invalid passwords
consecutively, the call will be disconnected.
5 Any new telephone messages will be played.
6 When playback ends, it will be possible to use the remote control features.
For the remote control features, see pp. 7-10 to 7-11.
7 Hang up the handset when you have finished.
• When forwarding is not possible:
You can set the fax to redial the forwarding number a certain number of times at specified
intervals when forwarding is not possible, such as at times when the forwarding number is
busy or the phone is unattended. If forwarding is still not possible after the fax redials the
forwarding number the specified number of times, the forwarding setting will be temporarily
canceled. However, the fax will dial the forwarding number again when any new telephone
messages are received.
• After any recorded messages have finished playing, if you do not enter a remote command, the
call will be disconnected.