Canon B820 - Manual (Page 47)

5-9
SE
ND
I
N
G
D
O
C
U
ME
NT
S
5
Redialing when the line is busy
There are two methods of redialing: manual redialing and automatic redialing. This section
explains these two methods.
Manual redialing _______________________________
Press [Redial/Pause] to dial the last number you dialed with the numeric buttons. (This starts
redialing regardless of whether automatic redialing is enabled.)
■ Canceling manual redialing
To cancel manual redialing, press [Stop]. You may then need to press [Start/Copy] for a few
seconds, then the fax will feed out the document. See Jams in the document tray, p. 9-1.
Automatic redialing ____________________________
■ What is automatic redialing?
When you are sending a document and the receiving party’s line is busy, the fax waits the
specified time and then dials the same number again. You can set the fax to redial several times
if previous attempts fail because of a busy signal.
Automatic redialing can be turned off and on. The number of redialing attempts and the time
interval between attempts can also be adjusted (see AUTO REDIAL, p. 8-3).
If all redialing attempts are unsuccessful, the fax will cancel the transmission. You can set the
fax to print an ERROR TX REPORT to remind you that the transmission was not completed
(see p. 8-3).
When automatic redialing is in use, the LCD displays AUTO REDIAL while it is waiting to
redial.
■ Canceling automatic redialing
1 Press [Stop].
If you want to cancel a memory-sending transmission while the fax is waiting to redial, you will
have to delete the document from memory (see p. 5-15).