SINGER 9100 User Manual
Page 9
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
REMOVING THE BOBBIN
1. Raise presser foot and turn hand wheel toward you
until needle is at its highest point.
2. Drawslide plate to the left.
3.
Reach down with left hand, open bobbin case latch
and lift out bobbin case.
4. Release latch and remove bobbin from bobbin case.
Latch
WINDING THE BOBBIN
1. To stop motion of needle, hold hand wheel A and
loosen clamp stop motion screw B. by turning it
toward you.
2. Place bobbin on bobbin winder spindle C and move
bobbin winder switch D to the right.
3. Place spool of thread on spool pin, and carry the
thread through the thread guides E and F, and
between bobbin winder tension discs G as shown
at right.
4. Draw thread up and through the hole of bobbin.
5. Hold thread end until a few coils are wound and
break off the thread end.
— 7—