Sew mg a seam – SINGER 9100 User Manual
Page 19
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
sew mg a seam
PIN BASTING
Pin basting
IS
a time-saver and can be used in
place of hand basting when you are straight
stitching seams in easy-to-handle fabric.
Use fine pins and place them so that:
• They are at right angles to the presser foot
and just nip into the fabric at the stitching
line.
• They do not extend under both sides of the
presser foot. Never place pins on the under
side of the fabric m contact with the feed
STARTING A SEAM
1. With presser foot raised, turn hand wheel
toward you to position the needle in fabric
about 1 '2 inch (1cm) from starting edge.
Lower the presser foot.
2. Set selector for desired stitch length.
3.
Raise stitch length selector to reverse and
backstitch to edge of fabric for reinforce
ment.
4.
Lower
stitch
length
selector
for
forward
stitching and stitch.
Pin Basting
Starting a Seam
— 1 7 —