SINGER 9100 User Manual
Page 8
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
NEEDLES AND THREAD
This machine uses needles Catalogue 2020 (15x 1),
available in sizes 9. 11, 14. 16 and 18.
For perfect stitching, select correct needle and thread
to correspond with fabric according to the table on page
5. Be sure to use like threads for both needle and
bobbin.
CHANGING THE NEEDLE
Raise needle bar to its highest point by turning the
hand wheel toward you. Loosen the needle clamp screw
and insert needle into clamp as far as it will go. with
the flat side of the needle to the right. Then tighten
needle clamp screw.
NEEDLE THREADING
1. Turn hand wheel toward you to raise take-up lever
to Its highest position.
2. Raise the presser foot.
3. Lead thread through all the threading points shown
at right and thread needle from left to right.
4 Draw about 4 inches of thread through eye of
needle
—6
—