Compaq 1200 - Manual (Page 47)

P RESARIO N OTEBOOK B EYOND S ETUP G UIDE U SING THE CD OR DVD D RIVE 5-3
1200 S ERIES
Removing a Disc
To remove a disc from the drive,
complete the following steps:
1. Press the Eject
’
button on
the drive.
2. Remove a disc from the tray, gently pushing down on the
center spindle while pulling up on the outer edges. Avoid
touching the surface of the disc.
3. Push the tray back into the drive until it locks into place.
Manually Ejecting a Disc
If you need to eject a disc when the power is off, complete the
following steps to eject the disc manually:
1. Make sure the power is off and any external power sources
are disconnected.
2. Insert a small rod or pin, such as a paper clip
(approximately 1/16 inch in diameter and at least 3/8 inch
in length) into the Manual Eject Hole and push firmly as
shown in the figure above.
3. Remove the disc from the tray, then gently push the tray
back into the drive until it locks into place.