Ploughitsig and molding, Ploughing and molding – Sears 113.241591 User Manual
Page 35
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Feed the workpiece by hand along the AUXILIARV
FENCE until the end is approx. 1 in. past the front
edge of the tabie. Continue to feed using the PUSH
BLOCK.
Hold the workpiece in position and install the PUSH
BLOCK by sliding it on top of the
AUXILIARV
FENCE/WORK
support
(This May Raise Guard).
PLOUGHItsiG AND MOLDING
PLOUGHING is grooving with the grain the long
way of the workpiece, using the fence. USE
Feafherboards and push sticks as recjuired.
MOLDING is shaping the workpiece with the grair
the long way of the workpiece, using the fence. USE
Featherboards and push sticks as required.
ploughing
35