Sears 113.241591 - Manual (Page 21)

12. Raise blade all the way up.
13. Carefully move fence against blade-
14. Move front bar until “0” mark on rip scale is
approximately in line \with indicator.
15. Move FRONT bar upwards until fence is
approximately 1/32 in. above table . . . tighten
screw at left end of bar.
NOTE: Fold a piece of newspaper making 8
thicknesses and place between rip fence and
table to act as a spacer. This will hold the fence
off of the table approx. 1/32 in.
16. Adjust rear bar so that the fence is
approximately 1/32 In. above table... make sure
it is square with fence guide bar rod . .. tighten
screw at end of bar.
17. Be sure top surface of extension is PARALLEL
to top surface of rear guide bar.
8 THICKNESSES
OF PAPER
18, Move fence to RIGHT edge of table . . . make
sure it is approx. 1 /32 i n. above table at front and
rear and tighten screws.
8 THICKNESSES
OF PAPER
aligning
rip
fence
The fence should slide easily along the bars and
aiways_ remain in alignment (parallel to sawblade
ThlSl&imls maSned by a spring uniferneath
the rip fence which bears against the front guide
To move the fence, loosen the lock^ handle and
grasp the fence with one hand at the front.