Sears 113.241591 - Manual (Page 27)

GETTING TO KNOW YOUR SAW
MITER GAUGE
LOCK HANDLE
8 TABLE INSERT
10
EXACT t I-CUT
9
SAWBLAOE
7
BLADE GUARD
ANTIKICKBACK
PAWLS
8 MITER GAUGE
HOLES FOR
ATTACHING FACING
4
TILT LOCK HANDLE
(UNDERNEATH TABLEJ
ELEVATION HANDWHEEL
TILT HANDWHEEL
1 on - off SWITCH
A.
1 ON-OFF SWITCH
CAUTION: Before turning switch on, make sure the
blade guard is correctly installed and operating
properly.
The On-Off Switch has a locking feature. THIS
FEATURE IS INTENDED TO PREVENT
UNAUTHORIZED AND POSSIBLE HAZARDOUS
USE BY CHILDREN AND OTHERS.
TO turn saw ON ... stand to either side of the
blade never in line with it . . . insert finger
under switch lever and put! END of lever out
Do not cycle the motor switch on and off
rapidly, as this may cause the sawbfade to
loosen. In the event this should ever occur,
allow the sawblade to come to a complete
stop and retighten the arbor nut normally, not
excessively. Never leave the saw while the
power is “QN".
TO turn saw OFF . . . PUSH lever in. Never
leave the saw until the cutting tool has come
to a complete stop.
C. TO lock switch in OFF position... hold switch
IN with one hand ... REMOVE key with other
,>:hand.,, ;■,. . ■; ■ ■■■
WARNING: FOR YOUR OWN SAFETY,
LOWER BLADE OR OTHER CUTTING
TOOL BELOW TABLE SURFACE. (IF BLADE
1$ TILTED, RETURN IT TO VERTICAL (90“)
POSITION). ALWAYS LOCK THE SWITCH
“OFF”. WHEN SAW IS NOT IN USE . * .
REMOVE KEY AND KEEP IT IN A SAFE
PLACE . . . ALSO ... IN THE EVENT OF A
POWER FAILURE (ALL OF YOUR LIGHTS
GO OUT) TURN SWITCH OFF ... LOCK IT
AND REMOVE THE KEY. THIS WILL
PREVENT THE SAW FROM STARTING OP
AGAIN WHEN THE POWER COMES BACK
ON.
KEY
(YELLOW PLASTIC)
B.
27