Sears 113.241591 - Manual (Page 25)

augning spreader
I
SPACE EQUAL TO APPROX.
3 THICKNESSES OF PAPER KERF WOOD
W A R N I N G : T O A V O I D I N J U R Y F R O M
accidental start , turn switch off and
REMOVE PLUG FROM POWER OUTLET.
BLADE
IMPORTANT: The SPREADER must always be
PARALLEL to the sawblade and in the MIDDLE of
the cut (KERF) made by the sawblade.
NOTE: The spreader is th inner than the width of the
KERF by approximately six thicknesses of paper.
SPACE EQUAL TO APPROX. LOOKING DOWN ON SAW
3 THICKNESSES OF PAPER
1 Make two folds in a small piece ( 6 x 6 in.) of
o r d i n a r y NEWSPAPER m a k i n g t h r e e
thicknesses. The folded paper will be used as a
“spacing gauge’’.
2 Install TRUSS HEAD SCREWS, SPREADER
CLAMP and WING NUTS to spreader bracket, Do
not tighten wing nuts. Place spreader between
spreader clamp and bracket. Move forward until
all three are in line. TIGHTEN WING NUTS.
PIECE O!
STRAIGHT W
3 Lift up both ANTIKICKBACK PAWLS , . . insert
one of the setscrew wrenches or a pencil in the
notches to hold the pawls out of the way.
4 Lay a piece of straight flat wood against the
' sawblade. Insert folded paper between spreader
and strip of wood.
5 MAKE SURE THE HEX NUTS UNDERNEATH
are loose .
6 Hold the spreader tightly against the wood and
‘ make sure the wood is against the saw blade.
TIGHTEN THE HEX NUTS.
This will align the spreader in the middle of the
cut (KERFV made by sawblade.
7 Lower the antikickback pawls. The end of the
' riqhthand (viewedfromfrontof saw) pawl should
m^ove down and clear the end of the small slot
pro^wed^i the insert If end of the right hand
HOLD SPREADER
TIGHTLY AGAINST WOOD
SPREADER
CLAMP
SPREADER
BRACKET
pawl strikes the metai of the insert, reposition tl
spreader support.
ADJUSTING MITER GAUGE
NOTE- The slots for the stop pin and dhe
aradStions are manufactured to very close
toTerances
which provide accuracy for average
In some cases where extreme
Sracvis requted. when making angle cuts, for
Sample': make a trial cut and then recheck ,t.
If necessary, the miter
Slightly to compensate for any inaccuracy.
1 Loosen the “knob” and pull “stop pin” OUT.
SSoW plW'O"
necessary.
LOCK KNOB
SQUARE
indicato
BLOCK
2S