Sears 113.241591 - Manual (Page 19)

4. Line up front and top of the extension with the
front and top of the table. Use a combination
square
to line-up these edges. SLIGHTLY
TIGHTEN nuts with a wrench.
5. If adjustment is necessary you should tap the
extension into position using a hammer and a
block of wood. Then firmly tighten nuts.
MOUNTING SWITCH
1. From among loose parts find the following:
2 Hex Head Screws, 5/16-18 x 3/4 in. long
2 Fiatwashers (dia. of hole 21/64 in.)
2 External Lockwashers
2 Hex Nuts, 5/16-18
2. Insert two 3/4 inch screws through two flat
washers then through holes in switch.
3. Insert screws through holes eight and ten in front
fence guide bar as illustrated.
4. Install two lockwashers and nuts. Tighten nuts.
JAM NUT
5/16-18
INSTALLING RIP FENCE GUIDE BARS
1. From among the loose parts find the following
hardware:
2 Hex Head Screws, 5/16-18 x 1-3/4 in. long
2 Hex Head Screws, 5/16-18 x 1 in. long
4 External Lockwashers, 5/16 in.
(approx. dla. O'f hole 5/16 in.)
4 Hex Nuts. 5/16-18
(approx. dla.
O'f hole 5/16 in.)
2 Spacers, 3/4 in. dia. x 1/2 in. long
2 Self-threading nuts
1 Fence Guide Bar Rod
2. Lay guide bars on saw table.
NOTE: The various holes in the bar allows them
to be positioned on this saw and also makes
them adaptable to other models.
3. Insert a 1-3/4 inch long screw through the
THIFiD hole IN THE FRONT BAR as illustrated
... Insert another 1-3/4 inch long screw through
the SEVENTH hole in bar.
4. Place spacers on screws.
LEFT SIDE OF
FBONT GUIDE BAR
19