Sears 113.241591 User Manual
Page 16
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
5. Remove the plastic covers from the end$ of the
SHAFT HOUSING.
мотов
END
SAW ARBOR
END
REMOVE
PLASTIC COVERS
6. Push the saw arbor end of the flexible shaft out
of
the
SHAFT
HOUSING
until
it
is
approximately 1 inch above the end of the
SMALL FERRULE.
PULL FLEXIBLE
^RBOR END
SHAFT OUT r
Insert the flexible shaft assembly through the
opening in the side of the saw base. Line up the
SQUARE END of the FLEXIBLE SHAFT with the
square hole in the arbor shaft, holding square
end of flexible shaft insertthe FLEXIBLE SH A FT
into the square hole in the arbor as far as it will
,go... V :
■■
. ■■■
IMPORTANT: Make sure the FLEXIBLE SH AFT is
inserted as far as it will go. Approximately 3/4
itiChi . .
.
,
8.
Insert SMALL FERRULE on SHAFT HOUSING
into the arbor shaft bearing hole.
Line up SHAFT RETAINER with holes in arbor
housing and fasten with three 10-32 x 3/8 Pan
Head Screws and three No. 10 Lockwashers-
Make sure this holds the small ferrule against
the arbor shaft bearing hole. Tighten screws.
Ы