To adjust buttonhole stitch density – Sears 385.4052LX200 User Manual

Page 54

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Hi Sew slowly and stop the machine when a buttonhole is

completed.

* The front bartack and left row first, then the back bartack

and right row.

|ioi Cut both needle and bobbin threads leaving about 10 cm

(4") thread ends.

Draw the needle thread to wrong side of fabric by pulling

the bobbin thread.

Then, knot the threads,

liii Insert a pin inside the bartack.

Then cut the opening with seam ripper.

Take care not to cut the stitches.

112 To repeat buttonhole sewing, turn the stitch selector to

then back to Q again, as shown.

Now, simply step on the foot control to sew an identical

buttonhole.

Ii2 When buttonhole sewing is finished, push the buttonhole

lever upward as far as it will go.

10 11

To adjust buttonhole stitch density:

Set the stitch length dial between 0.5 and 1.0 to adjust the

buttonhole stitch density.