Canon DR-5060F - Manual (Page 24)

22 Connecting to a Computer
Setting the SCSI ID and Terminator
Set the SCSI ID and terminator using the DIP switch on the rear of the scanner.
The DIP switch is ON at the up position and OFF at the down position.
SCSI ID switch
Terminator ON/OFF
switch
Default
(Terminator: OFF, SCSI ID = 2)
■ Setting the SCSI ID
Set the SCSI ID by combining the settings of switches SW2 to SW4.
Set unique SCSI IDs to any other built-in SCSI devices or SCSI devices
connected to the computer.
SCSI ID
0
1
2
3
4
5
6
7
SW2
ON
ON
ON
ON
OFF
OFF
OFF
OFF
SW3
ON
ON
OFF
OFF
ON
ON
OFF
OFF
SW4
ON
OFF
ON
OFF
ON
OFF
ON
OFF
NOTE
The default SCSI ID is set to 2. Assign SCSI ID numbers ranging from 0 to 7 for
each SCSI device. Do not select 7 as this is normally assigned to the SCSI
controller. If a SCSI hard disk is set as the startup disk, do not use 0. Normally
0 is assigned for the startup disk.