Canon DR-5060F - Manual (Page 23)

21
Preparation Bef
ore Use
2
Connecting to a Computer
Connecting to a Computer
Connect the scanner to the computer.
CAUTION
Before you connect the scanner to the computer, be sure to turn both the
scanner and the computer OFF.
Connecting the SCSI Cable
Connect your computer to the scanner using the SCSI cable.
Two half-pitch 50-pin SCSI connectors are located on the rear of the scanner.
Insert the SCSI cable from the computer into one of these connectors.
To connect another SCSI device to the computer, insert the other SCSI cable into
the vacant SCSI connector on the rear of the scanner, and connect the other end
of the SCSI cable into the SCSI device in a daisy chain.
Half-pitch 50-pin
(pin type)
Insert into either of
these two ports.