Canon DR-5060F - Manual (Page 17)

15
About DR-5060F
1
Names and Functions of Parts
(3) Backup key
This key displays and changes the scanner operation mode:
Lit (Backup mode):
In this mode, scanned images are being
photographed on microfilm while they are being
transferred to computer.
Out (Scanner Only mode): In this mode, scanned images are not
photographed to microfilm.
Blinking (Filmer Only mode): In this mode, scanned images are not transferred
to computer, and are only photographed to
microfilm.
The default setting for this scanner is the Backup mode. Pressing this key turns
the lamp in the key OFF and sets the scanner to the Scanner Only mode, and
holding this key down for five seconds sets the scanner to the Filmer Only
mode.
(4) Space/Trailer key
This key is enabled in the backup and film only modes when the camera unit is
placed on this unit. Pressing this key takes up spaces on the film. Holding this
key down for three seconds feeds the trailer film so that the film can be taken
out of the camera unit. During taking up of spaces and feeding of trailer film,
the rightmost LED on the remaining film indicator blinks and the Start key turns
to red.
(5) Count Only key
Pressing this key lights the lamp in the key and sets the Count Only mode.
In this mode, document pages that are fed are neither scanned nor
photographed. They are only counted. For details on this mode, see page 41
“Count Only mode.”
(6) Clear/Stop key
This key is used to stop scanning midway, cancel the operation mode you have
set, and to cancel errors displayed on the counter display.
Holding this key down for at least two seconds clears the count displayed on
the counter display. If the counter display is set for odometer indication, the
currently displayed odometer value is cleared. If the counter display is set for
file address indication or page address indication, both the file address and
page address are cleared.
(7) New File key
Pressing this key notifies the scanner and filmer of a new file.
When you press this key and start scanning the next document, the images
sent to the computer are saved in a different folder or under a different name to
the previously scanned document, and the file mark is photographed on the
film to indicate a new file.
MEMO
In the Backup mode and Scanner Only mode, the image to be saved or the
new file mark is controlled according to the settings on the application. For
details on application settings, refer to the separate “ISIS/TWAIN Driver
Instructions” or “Scanning Utility 5060 Instructions.”