Winco DPG-2145-001 - Manual (Page 9)

Manual 36526F DPG-21XX-00X Digital Controllers
Woodward 1
Chapter 1.
General Information
Introduction
This manual provides information on the following DPG controllers:
DPG-2101-001 and
DPG-2101-002
DPG-2145-001 and
DPG-2145-002
DPG-2146-001 and
DPG-2146-002
DPG-2155-001 and
DPG-2155-002
The DPG-21XX-00X digital controller is used primarily to govern diesel or gas fueled
engines of generator sets. This microprocessor based, digital controller performs across
a wide speed range and allows adjustment of set speed and gain parameters with the
built-in user interface. The COMM port provides access to all other controller settings,
allowing adaptation to each application during service and initial configuration.
Separately programmable Proportional, Integral, and Derivative gains are provided for
tailoring controller response to many engine applications. Other adjustments include
acceleration and deceleration ramp rates, idle speed set, hold time, and more.
Properly tuned, this controller delivers fast engine response to speed or load change
while providing precise stable isochronous operation.
The control
ler’s internal FAILSAFE reacts instantly to loss of the engine speed signal,
allowing the actuator to return to minimum fuel.
Features include:

Isochronous speed control

User friendly / operator adjustable

Precision frequency control

Superior temperature stability

Reverse battery protection

Input voltage range: 9 –30 Vdc

Remote setup

Serial communication port
Actuator Compatibility:
DYNA 2000 DYNA 7000 DYNA 8000 APECS 0150
DYNA 2500 DYNA 70025 DYNA 8200 APECS 0250
DYNA 10141 DYNA 8400 APECS 0300
APECS Linkage Free Integral Type
Other Models Available:
DPG-2100 Series
– for Genset Applications
DPG-2300 Series – for Off-Road Vehicles
DPG-2400 Series – for EFC Valve Applications