Winco DPG-2145-001 - Manual (Page 39)

Manual 36526F DPG-21XX-00X Digital Controllers
Woodward 31
DPG-2146-00X
NO. NAME FUNCTION
1 BAT+ Battery positive (9 –30 Vdc)
2 BAT- Battery negative
3 ACT Actuator drive output
4 ACT Actuator drive return
5 IGN TACH Ignition tachometer signal input
6 IGN GND Ignition ground signal
7 SHIELD Ground connection for cable shielding
DPG-2155-00X
NO. NAME FUNCTION
1 BAT+ Battery positive (9 –30 Vdc)
2 ACT Actuator drive output
3 Not Labeled Digital input common
4 INC
Digital input to increase selected set speed
(Active when tied to Pin 3)
5 MPU+ Magnetic pickup signal inputs
6 SET SPD 2
Set Speed B selected when this pin tied to
Pin 12
7 BAT- Battery negative
8 ACT Actuator drive return
9 SHIELD Ground connection for cable shielding
10 DEC
Digital input to decrease selected set speed
(Active when tied to Pin 3)
11 MPU- Magnetic pickup ground
12 SET SPD 1 Set Speed A selected when this pin is open
To prevent damage to the controller, make sure that it is
wired in accordance with the wiring instructions and
diagrams in this manual.

Do not tin the leads before placing them into
the terminals.

Ensure the terminals are tightened properly to
secure wires.