Winco DPG-2145-001 - Manual (Page 10)

Manual 36526F DPG-21XX-00X Digital Controllers
Woodward 2
Chapter 2.
Controller Specifications
The controller’s main electrical and mechanical specifications are listed here along
with several performance characteristics. DPG-21XX-00X Series controllers are
available in five hardware configurations.
Configurations
Model No.
Connector Style
Options
Speed Sensing
Options Adj.
Set
Speeds
Remote
Speed
INC and
DEC
7-wire
Euro
12-pin
Molex
Magnetic
Pickup
Ignition
Sense
DPG-2101-00X * * 1 + idle
DPG-2145-00X * * 2 + idle *
DPG-2146-00X * * 1 + idle
DPG-2155-00X * * 2 + idle *
Electrical
Operating Voltage Range: 9 –30 Vdc *
Rated Output Current: 7 A Maximum (continuous)
Maximum Surge Current: 14 A (not to exceed ten seconds)
Connections:
Terminal strip with 7 Euro style
terminals or a quick connector with
12 pins
Input Signal from Magnetic Pickup: 2.0 VAC RMS minimum during cranking
Input Signal from Engine’s
Ignition System:
40 V minimum during cranking
(*) All cabling for these controllers is limited to less than 30m (98.4’).
Power cabling is limited to less than 10m (32.8’) in total length.
See wiring diagrams for specific cable types required.
Mechanical
Ambient Operating Temperature: -40°F to +185°F (-40°C to +85°C)
Sealing:
Oil, water, and dust resistant via
conformal coating and die cast
enclosure
Weight: 10 oz. (284 g)