Tuffy Security 044 - Manual (Page 3)

CUTTING INSTRUCTIONS FOR JEEP
WRANGLER TJ 2001 & UP
MOPAR PART# 5HJ98LAZAB PLASTIC DRINK HOLDER
INSERT IN FRONT SHIFTER CONSOLE FOR JEEP TJ WITHOUT STOCK
FULL CONSOLE
Applies to Jeep Wrangler TJ 2001 and up with two drink holders in the original front shifter console. The
original plastic drink holder will have to be cut to allow the front of the console to sit in the proper position.
If the drink holder is not cut the console will have to be mounted back behind the drink holder.
1.
Line up the cut template on the front of the plastic drink holder
2. Using the template mark the cut location on the plastic drink holder
WARNING! Mark and cut the drink holder carefully, Tuffy does not sell
replacements for this part (Part# 5HJ98LAZAB) it will have to be ordered
from a local Mopar dealership.
3.
After marking the cut location secure the drink holder for cutting. (Gripping the back side of the two
drink holder extrusions in a vice using a cushion to prevent damage to the drink holder is advised)
4. Carefully cut the drink holder using a hacksaw.
5. De-bur the cut edges with a file.
6. Check the fit, additional cutting or filing may be required to fine-tune the fit.