Tuffy Security 251 - Manual

Page 1 of 2 - 9/8/2010 – Rev122006
INSTALLATION INSTRUCTIONS
TJ 03-06 & LJ Security Drawer #251
(Fits vehicles where the driver’s side seat flips all the way up. These vehicles HAVE
the CAFS code on the Jeep build sheet = “Easy Access Driver Tip & Slide Seat” or
“Easy Access Driver Seat”)
Please read and fill out the enclosed warranty registration card to activate your warranty.
PARTS CHECKLIST
Enclosure Drawer #5 Bolt-block plate
TOOLS NEEDED
 ½” Socket and Ratchet
 T-50 Torx socket or wrench (Only required for optionally removing the entire seat)
 5/64”
Allen wrench
 5/16”
Wrench
 Flat head screwdriver
PLEASE READ ALL INSTRUCTIONS THOROUGHLY BEFORE STARTING INSTALLATION.
Warning! Do not operate the vehicle without the drawer locked shut. If left unlocked
normal vehicle movements while driving could cause the drawer to open creating an
unsafe situation. As a result from maximizing the drawer storage height the seat (forward
& aft) re-position lever is very close to the top of the enclosure and can create a pinch
point so use caution in adjusting the seat position.
1. Remove the drawer from the enclosure. To remove the drawer from the enclosure, pull the drawer out
as far as it can go then locate the small black plastic stops visible on the ball bearing drawer slides.
One of the black stops will need to be deactivated by pressing down and the other one pulled up. Be
careful not to break plastic stops. While deactivating the stops push the center slide section back into
the drawer enclosure off of the front slide section attached to the drawer until they are separated. To
reinstall, line up the slide sections and push the drawer in gently, do not force it or it can be damaged.
2. Remove the (2) original front mounting bolts #8.10 holding the front of the Drivers side seat to the
body. It is not necessary to remove the rear bolts although it does make it easier to slide the Tuffy
drawer under the seat brackets. (See Figure 1)
3. Remove the one #7.2 screw, #7.3 washer and #7.4 nut holding the rear of the left slide to the enclosure
as illustrated. The floating center slide will need to be positioned to allow access to the #7.2 Allen
head screw. This screw will be reinstalled later to attach the #5 Bolt-blocker plate. (See Figure 1)
4. Insert the drawer enclosure under the driver’s seat with the (2) tabs on the enclosure under the original
seat mounting brackets. (See Figure 1)