Tuffy Security 031 User Manual
Installation instructions

Page 1 of 2 - 1/28/2008 – Rev011607
INSTALLATION INSTRUCTIONS
SECURITY LOCKBOX SET #020 AND #031
Please read and fill out the enclosed warranty registration card to
activate your warranty.
PARTS CHECKLIST
(8) 5/16” x 1-1/4” Bolts
(8) 5/16” Nylock Nuts
(16) 5/16” Washers
Rubber Seal Package
(6) #4 Nuts
(6) #4 Washers
(4) 5/16” Hole Plugs
TOOLS NEEDED
• Electric
drill
• 3/8” Drill bit
• Marker or pencil
• Knife
• ½” Socket and ratchet
• ½”
Wrench
• ¼” Wrench or Socket and Ratchet
• Silicone
sealant
(Recommended)
PLEASE READ ALL INSTRUCTIONS THOROUGHLY BEFORE STARTING INSTALLATION.
This section applies to Part # 020 only
1. Bolt your speaker to the Tuffy box by placing the speaker cloth between the speaker and the box and
securing with fasteners provided with the speaker.
2. Route speaker wires through either the hole in the bottom of the box or the hole on the side of the box.
3. If you did not route the wires through the hole in the side of the box, plug the hole with the 5/16” plug
provided.
4. Connect speaker wires to speaker in accordance to the speaker installation manual.