Tuffy Security 297 - Manual (Page 3)

Page 3 of 3 – 10/23/2012 – Rev 10/23/12
6. Install the #1 Lid with trim pieces into the vehicle by positioning the rear edge side tabs under the hardtop mounting lip
at the rear of the vehicle body and tilting the Lid downwards to meet up with the #2 Front Panel. The #1 Lid is
intended to lap over the front of the #2 Front Panel. (Figure 3)
FITMENT AND SEALING NOTES:
***Note: Be sure to fully insert the #1 Lid rear tabs under the hardtop mounting lip before tilting the Lid downwards.
***Note: Be sure to keep the rubber edge trim in position when installing the #1 Lid.
FIGURE 3
7. Install the (2) #4.1 carriage bolts from the front of the installed enclosure. Install the (2) #4.2 washers and (2) #4.3
nuts from inside the enclosure. The two panels have slotted mounting holes to allow for the tailoring of the enclosure
fit and position – it may be necessary to raise or lower the #1 Lid a small amount. Pull the #1 Lid rearward as far as
possible. Re-install the #5.2 OEM roll bar bolts and tighten to factory specifications. Tighten the #4.3 nuts to 15 ft-lbs.
Finally, tighten the #5.4 OEM bolts to factory specifications. (Figure 4)
FIGURE 4
Call (970)564-1762 for Technical Support