Tuffy Security 131 User Manual
Page 2
Page 2 of 2 - 1/28/2008 – Rev122006
3. Remove the two inside bolts holding the rear down-tube of the roll-bar to the Jeep tub. Save these bolts, you will reuse them.
4. Remove the two seat belt harness bolts located on each side of the Jeep tub. Save these bolts, you will reuse them.
5. Fasten the enclosure to the Jeep tub through the roll-bar mounting holes and the seat belt harness holes using the original Jeep
hardware. In some applications a longer bolt with a washer is necessary, in these cases use the (2) 3/8 x 1 ½” bolts and 3/8”
washers on the roll-bar and (2) 7/16 x 2” bolts and 7/16” washers for the seat belt mounts. (See figure 3)
6. Install the rubber seal on the drawer enclosure where the drawer makes contact.
7. Insert the drawer and check sliding and lock operation.
Call (970) 564-1762 for Technical Support
- 082 (2 pages)
- 089 Manual (3 pages)
- 089 Installation Manual (1 page)
- 101 (2 pages)
- 073 (3 pages)
- 198 (2 pages)
- 189 (1 page)
- 292 (2 pages)
- 282-BTL (1 page)
- 137 (2 pages)
- 295 (3 pages)
- 862 (2 pages)
- 863 (3 pages)
- 311 (2 pages)
- 312 (2 pages)
- 046 (3 pages)
- 145 (4 pages)
- 297 (3 pages)
- 296 (3 pages)
- 240 (10 pages)
- 238 (2 pages)
- 058 (3 pages)
- 219 (2 pages)
- 195 (2 pages)
- 144 (2 pages)
- 274 (10 pages)
- 139 (3 pages)
- 157 (10 pages)
- 052 (2 pages)
- 164 (1 page)
- 104 (1 page)
- 043 (1 page)
- 027 (2 pages)
- 035 (2 pages)
- 108 (2 pages)
- 149 (2 pages)
- 049 (2 pages)
- 036 (2 pages)
- 160 (3 pages)
- 289 (2 pages)
- 287 (3 pages)
- 283 (3 pages)
- 309 (2 pages)
- 182 (2 pages)