Tuffy Security 145 - Manual (Page 3)

Page 3 of 4 - 1/28/2008 – Rev122006
13. Install the #18 Right and #17 Left Lid Panels using (4) ¼-20 x 1 ¼ bolts #14.11, (4) Nylock nuts #14.10 and (12) ¼”
Nylon Washers #14.12. Be sure to insert one nylon washer between each Lid Panel connection and the other
mounting panel. Do not over tighten, the lid should pivot easily but not be so loose that it will rattle. (See Figure 1)
NOTE: If you have the OEM subwoofer do not install #18 Right Lid Panel.
14. Gently reinstall the drawer into the enclosure. DO NOT FORCE IT OR THE DRAWER SLIDE BEARINGS WILL BE
DAMAGED!
15. Check to make sure the Handle does not hit the rear door on the FJ and the rear seat latches into the upright position.
To adjust the location, loosen the mounting hardware and maneuver it to the correct position then refasten the
mounting hardware.
16. Tip: Place the carpet removed from the floor on top of the drawer to prevent surface scratches on the drawer.
IMPORTANT!
If the jack has been left in the original location it is imperative that everyone who may
need to use it becomes familiar with the procedure for removing it after the drawer has been installed. If anyone
who will need to access the jack will not be able to remove the jack it should be relocated inside the drawer or
another secure location. Do not store it or any other heavy objects in the storage under the side flaps they are
not designed to retain items in an accident.
FIGURE 1 (VIEW FROM REAR DOOR)