Figure 1 figure 2, Figure 3 figure 4 – Tuffy Security 863 User Manual
Page 2
Page 2 of 3 - 06/23/2008 – Rev05192008
FIGURE 1
FIGURE 2
(STANDARD
LID)
(STANDARD
LID)
FIGURE
3
FIGURE
4
(STANDARD
LID)
(STANDARD
LID)
INSTRUCTIONS TO MOUNT THE GAS STRUT ASSEMBLY IN NON-STANDARD LID HINGE CONFIGURATIONS
PART# 139 JK CONSOLE INSERT, OPENS APPROXIMATELY 82 DEGREES MAX)
1. Remove the padded cushion and mark the spots for (2) ¼” holes to be drilled in the lid to mount the #7 Bracket. Measure from
the rear and right side on the outside top of the lid as illustrated. Drill the (2) ¼” holes in the lid. (See Figure 5)
2. Mark the holes on the right side panel for drilling a 1/4” holes as illustrated and drill it out. (See Figure 5)
3. Fasten the #4 Ball studs to each #7 Brackets as illustrated
4. Attach the top end of the #3 Gas strut to the #7 Bracket for the lid and fasten it to the holes drilled in the lid using the illustrated
hardware. (See Figure 6)