TeeJet GuideLine SmartPad II - Manual (Page 124)

3-70 Chapter 3 - Real-Time Guidance
Mapping Points and Hazards
SmartPad II
Software Version 4.02
Marking a Named Hazard
The map object Named Hazard allows you to mark a hazard at the vehicle location. The map object Named Hazard
can be used later in Hazard Detection, page 3-71, to notify the operator of potentially hazardous objects or features
with in the field. Hazard detection will not work with point objects. When SmartPad II is setup to map a Named Haz-
ard, a Hazard button will be added to the view page button bar, see Figure 3-98. To map a Named Hazard drive to the
location of the object or feature you want to map, this location should coincide with the location of your GPS antenna.
Next, highlight the Hazard button in the button bar using the keys then press . Notice that when you high-
light the Hazard button, the name of the hazard appears in the information box at the bottom of the view page.
Figure 3-98: Mapping a Named Hazard