TeeJet CenterLine v1.05 - Manual (Page 25)

CenterLine
Software Version 1.05
Lightbar Setup
Lightbar setup allows the selection of several parameters related to the lightbar. There are five
lightbar settings: Drive Sensitivity , Display Mode , two selectable mes-
sages: and , and (See Figure 19 and Table 5).
Figure 19: The Lightbar Setup Flow
Setting Name Default Value
Change at 1st
Time Start up
Spacing 1.5 ft. Optional
Mode Vehicle Optional
Text 1 X-Track Error Optional
Text 2 Applied Area Optional
Steer bar? No Optional
Table 5: Lightbar Menu Item Default Settings
Spacing
The Spacing setting allows the selection of the distance that a single light on the lightbar LEDs rep-
resents.
To change the Spacing setting, go to Lightbar setup, scroll until is displayed in the
text window, and press Enter. To increase the spacing distance press UP; to decrease the spacing
press Down. Press the Enter key when the desired spacing is set. The Spacing range is 0.5 ft. to
9.5 ft., in 0.5‘ increments.
CenterLine
CenterLine Setup
19