TeeJet CenterLine v1.05 - Manual (Page 21)

CenterLine
Software Version 1.05
Width
The Guidance setup parameter Width is the distance between guidelines. This width is typically
the vehicle implement width or spread area. Setting this width slightly smaller than the actual width
reduces skips. Setting this width slightly larger than the actual width reduces overlap.
To set the Width setting, go to , scroll with Up or Down until is displayed,
and press Enter. To increase the width press Up; to decrease the width press Down. Press Enter
when the desired width is set. The width value increments in 0.5 ft. intervals.
Figure 12: Setting the Guidance Width Value
Antenna
The Antenna sub-menu defines the spatial relationship between the GPS antenna and the vehicle
implement or delivery point. The GPS antenna should always be mounted along the vehicle center
line (See Figure 16). The two Antenna menu settings are Direction and Distance.
To enter the Antenna sub-menu, go to , scroll until is displayed in the
text window, and press Enter. As mentioned there are two settings under Antenna:
and . The text window should display . Use Up or Down to move
between the and settings. Press Enter when the desired setting is
in the text window.
Figure 13: Accessing the Antenna Sub-Menu
Direction
The Direction setting is the direction from the GPS antenna to the swath or delivery point (See Fig-
ure 16).
To change the Direction setting, go to the Antenna sub-menu of Guidance setup, scroll until
is displayed in the text window, and press Enter. Using Up or Down scroll through
the direction pick list (See Figure 14) until the desired direction is displayed in the text window.
Press Enter to save the setting and return to the Guidance setup menu.
CenterLine
CenterLine Setup
15