Auto ping (sv1108ippow only) – StarTech.com SV1108IPPWEU User Manual
Page 34

Instruction Manual
27
After you have made your schedule settings, click Add. The schedule is summarized in
the list at the bottom of the panel. To remove the outlet’s schedule, select it in the list
and click Delete.
Auto Ping (SV1108IPPOW only)
The section allows you to use an ICMP ping command to check if the attached device
is functioning properly. This function is detailed in the following table:
Enable
Put a check in the checkbox to enable
this function.
Ping Address
Enter the IP address of the device to be
be pinged in this field.
Interval
This field sets how often the specified
device is pinged, in second intervals.
Enter a value between 1 and 255.
Fail Count
This field sets how many times the
device is allowed to fail to respond to
the ping before an action is taken (see
below). Enter a value between 1 and 99.