Casio FX-9750GII - Manual (Page 226)

8-15
DrawFTG-Con, DrawFTG-Plt No parameters
Function: This command uses values in a generated table to graph a function.
Description:
• This command draws a function graph in accordance with conditions defined within the
program.
• DrawFTG-Con produces a connect type graph, while DrawFTG-Plt produces a plot type
graph.
DrawGraph No parameters
Function: This command draws a graph.
Description: This command draws a graph in accordance with the drawing conditions defined
within the program.
DrawR-Con, DrawR-Plt (Not included on the fx-7400G II ) No parameters
Function: These commands graph recursion expressions, with a
n
( b
n
or c
n
) as the vertical axis
and n as the horizontal axis.
Description:
• These commands graph recursion expressions in accordance with conditions defined within
the program, with a
n
( b
n
or c
n
) as the vertical axis and n as the horizontal axis.
• DrawR-Con produces a connect type graph, while DrawR-Plt produces a plot type graph.
DrawR 3-Con, DrawR3-Plt (Not included on the fx-7400G II ) No parameters
Function: These commands graph recursion expressions, with 3 a
n
( 3 b
n
or 3 c
n
) as the vertical
axis and n as the horizontal axis.
Description:
• These commands graph recursion expressions in accordance with conditions defined within
the program, with 3 a
n
( 3 b
n
or 3 c
n
) as the vertical axis and n as the horizontal axis.
• DrawR 3-Con produces a connect type graph, while DrawR3-Plt produces a plot type graph.
DrawStat
Function: This draws a statistical graph.
Syntax: See “Using Statistical Calculations and Graphs in a Program” on page 8-25.
Description: This command draws a statistical graph in accordance with conditions defined
within the program.
DrawWeb (Not included on the fx-7400G II )
Function: This command graphs convergence/divergence of a recursion expression (WEB
graph).
Syntax: DrawWeb [, ] =
Example: DrawWeb a
n +1
( b
n +1
or c
n +1
), 5 =
Description:
• This command graphs convergence/divergence of a recursion expression (WEB graph).
• Omitting the number of lines specification automatically specifies the default value 30.