NORAC UC4+BC+AN2 - Manual (Page 33)

30
Figure 34: Valve Cable Connections
12. Connect the CAN Node cable (C02B)
to the 4-pin AMP plug on C11 (Figure
35).
13. Route the CAN Node cable (C02B) to
the roll sensors. Follow existing cables
and/or hydraulic lines.
14. Connect the sensor branch cable (C02)
to the 4-pin AMP plug on C02B
(Figure 35).
15. Route the sensor branch cable (C02) to
the wing and main sensors. Follow
existing cables and/or hydraulic lines
along the boom.
16. Cable-tie the installed cables every 12
inches.
IMPORTANT:
Provide enough slack in all cables to
account for the movement of the
main section, parallel lift, and
FOLDING boom movement.
Figure 35: Cable Configurations: C11,
C02B and C02