NORAC UC4+BC+AN2 - Manual (Page 23)

20
4.6.1.2 Chassis Roll Sensor Mounting
1. It is often best to cable tie the chassis
roll sensor in place. When mounting
the chassis roll sensor follow the
guidelines and refer to Figure 21.
The chassis roll sensor must be
mounted on a portion of the
sprayer that does not pivot and is
as close to the boom frame roll
sensor as possible (Figure 19).
a) Make sure you are using the roll sensor
with the temperature probe (E03).
b) Ensure the roll sensor is level with
respect to the chassis.
c) The AMP (circular) connector MUST
exit towards the right hand wing.
d) Make sure the temperature probe is
able to reach the side of the valve block.
Figure 21: Chassis Roll Sensor
Mounting
2. Refer to Section 4.6.4 for mounting
the temperature probe.